Please note, the image above is of the whole range of storage heaters available, this page only refers to one heater.
Our slim and compact Elnur storage heaters provide comfortable warmth throughout the day and are very economical to use as they operate using low cost off peak electricity tariffs such as Economy 7, they charge up during the night when electricity is cheaper and then disperse heat during the day.
These combined heaters also incorporate a convector heater to provide additional heat as and when required, this is controlled by an integral thermostat. A separate on/off switch for the convector is situated on the side of the unit.
With automatic charge control, two sensors are used to monitor the room and core temperature, allowing the correct level of charge to be taken without the need for user adjustment. This can result in up to 15% in running cost saving compared with a conventional storage heater and meets the requirements of Building Regulation Part LI, which requires all electrical storage heaters installed in new buildings to be fitted with automatic charge controls.
The heaters can be used anywhere in the house even in bathrooms if located outside zone 2 provided the installation complies with IEE regulations.
The controls are conveniently positioned on top of the storage heater. Once the required settings are selected no further adjustment is necessary. The unit features a manual adjusting input charge controller, room temperature boost control and front grille for efficient heat distribution, the unit is suitable for domestic or commercial use.
The storage heater stores heat in bricks surrounded by low resin wool insulation and has sheathed elements. The unit has a thermal cut-out with a manual reset control.
Finished in willow white the unit is IPX2 Rated is CE and BEAB Approved and carries a full two year manufacturers warranty.
Important – These units are extremely heavy and will be delivered to the GROUND FLOOR of your premises only, the bricks are delivered outside of the unit and will need to be installed when in position, we will endeavour to let you know the delivery date with as much advance notice as possible but will not be able to give exact timings.
Delivery for this item is typically 4-5 days
Output: 3.4kW (with 1.75kw convector)
Dimensions HxWxD: 730 x 990 x 170mm
No. Of bricks: 16